King County Navigation Bar (text navigation at bottom)
Public Health - Seattle & King County
Site Directory

Public Health Webpage Directory

Public Health Center & Office Locations

For Care Providers

Health Advisories & Resources

For Educators

Health Educators Toolbox

About Us

History & Profile

Jobs

Employee Directory

Contact Us

Public Health
Seattle & King County
401 5th Ave., Suite 1300
Seattle, WA 98104

Click here to email us

Phone: 206-296-4600
TTY Relay: 711

magnifying glass Advanced Search
Search Tips
Home » Disaster response » Flooded basement

Disaster response
Cleaning a basement after a flood

flooded houseBasements flooded with surface water, seepage through walls, or backflow from sewer lines often suffer little or no structural damage from the water, because the water inside braces the walls against the pressure of outside water and waterlogged soil.

gray bullet

How and when do I pump the water out?

gray bullet

How should I clean the basement?

gray bullet

How do I avoid shock hazards?

gray bullet

How do I get rid of odors?


How and when do I pump the water out?

Use the following instructions for draining the water:

  • Do not drain water inside the basement until most of the water on the outside of the walls has gone down. This will prevent the walls from being pushed in or the floors from heaving.
  • If you have a large amount of water in your basement or if there is no basement drain, you may need to buy or rent a sump pump to get rid of the water.
  • If your electrical panel is located in an area of your home that has been flooded, you will be unable to use an electric sump pump unless you use a pump driven a 12-volt auto battery. A gasoline engine pump may be used if exhaust can be vented to the outside.
  • Start pumping water out of your basement if the water inside is higher than the flood water level outside. You may need a measure to determine this.
  • Stop pumping when the two water levels become equal.
  • Pump the basement water out at the same rate at which the flood waters recede.
How should I clean the basement?
  • Shovel mud from the basement as soon as all water has drained or has been pumped out to allow floors and walls to dry.
  • Remove silt and dirt stains by rinsing concrete walls and masonry foundation walls with a high pressure hose.
  • If stains remain on the walls, scrub them with a stiff bristle brush and household detergent. Begin at the top and work down. Rinse often with clear water.
  • Start drying the basement as quickly as possible in order to minimize wood decay or growth of mold.
  • Open all doors and windows to allow the moisture to flow outside.
  • Buy or rent a fan or dehumidifier to speed up the drying process.
  • If you are sensitive to mold or mildew, wear a mask or respirator containing an appropriate filter.
How do I avoid shock hazards?
  • Be careful before using any electric appliance in a house that has been flooded.
  • Never turn on wet electric appliances because they may cause an electric shock, overheat, or start a fire.
How do I get rid of odors?
  • If ventilation does not remove odors:
    • Mop concrete floor and walls with a bleach solution (3/4 cups of household bleach to a gallon of water).
    • Rinse and dry after 5 minutes.
    • Open windows when applying the bleach solution.
  • Place a lump of dry charcoal in an open tin/metal container to absorb odors.

Updated: Friday, July 20, 2007 at 08:49 PM

All information is general in nature and is not intended to be used as a substitute for appropriate professional advice. For more information please call (206) 296-4600 (voice) or TTY Relay: 711. Mailing address: ATTN: Communications Team, Public Health - Seattle & King County, 401 5th Ave., Suite 1300, Seattle, WA 98104 or click here to email us.

King County | News | Services | Comments | Search

Links to external sites do not constitute endorsements by King County.
By visiting this and other King County web pages, you expressly agree to be bound by terms
and conditions of the site. The details.